![]() ![]() You can perform this check by first installing the cpu-checker on your platform and then entering sudo kvm-ok in a terminal prompt. ![]() I enable KVM during the guest VM installation as QEMU virtualization and performance will be much faster and efficient if KVM is enabled at the time of compilation. Before proceeding ahead, you need to check if your current hardware supports the necessary Virtualization Extensions for KVM. ![]() configure -target-list=aarch64-softmmu -prefix=$HOME/usr -enable-debug -extra-cflags='-g'ġ. Switch to the QEMU directory and prepare a native build directory. $ sudo apt-get install git libglib2.0-dev libfdt-dev libpixman-1-dev zlib1g-devģ. OvS Setup with DPDK Configuration for OvSġ. Install the following package requirements if they are not present on your system.If you have not completed those steps, please refer to Chapter 1: Build and Install of this blog series.īefore proceeding ahead, please complete the exact steps listed under the following headings from my previous blog - Chapter 2: Setup for PHY-PHY Test This Arm platform which serves as the Device Under Test (DUT) for the traffic test. This blog assumes that you have built and installed OvS with DPDK in your home directory on your Arm platform. This blog describes how to setup OvS with DPDK to run the PHY-VM-PHY or vHost-Loopback traffic test on an Arm platform. This is Chapter 3 of the blog series: Open vSwitch with DPDK on Arm. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |